MIL-P-80041D
4.8.2 Operational test. Each press shall be operated at no load for not
less than one-half hour.
Proper operation of all controls, motors, adjusting
--
mechanisms, a n d a c c e s s o r i e s s h a l l b e v e r i f i e d d u r i n g t h e t r i a l p e r i o d .
E a c h press
shall be tested to determine
4.8.3 Alignment tolerance test.
he alignment t o l e r a n c e r e q u i r e m e n t s o f 3 . 6 . T h e a l i g n m e n t
compliance with
to and subsequent to the performance
tolerance test shall be performed prior
Any machine adjustments required to comply with 3.6
test given in 4.8.4.
during or after the performance test shall be cause for rejection.
4 . 8 . 4 T o n n a g e c a p a c i t y t e s t . T h e press
shall be tested for conformance
with the tonnage capacity requirements in t a b l e s I , I I , o r I I I f o r t h e s i z e
press specified.
Unless-otherwise specified (see 6.2), the method used shall
be of the manufacturer's standard test procedure f o r t h e v e r i f i c a t i o n o f
machine tonnage.
4.8.5 Electromagnetic interference control test.
Equipment requiring elec-
tromagnetic interference control shall be tested for compliance with 3.3.8
using the procedures given in MIL-STD-462.
4.9 Packaging inspection. Packaging of each item shall
be
inspected
to
d e t e r m i n e compliance with t h e r e q u i r e m e n t s o f s e c t i o n 5 .
PACKAGING
5.
5.1 Packaging requirements. The requirements for packaging shall be in
accordance with MIL-M-18058.
NOTES
6.
(This section contains information of
that
a general or explanatory nature
may be helpful, but is not mandatory.)
Presses specified herein are intended
for
forming,
6.1 Intended use.
blanking, or shaping metal and non-metallic materials.
Acquisition
documents
should
specify
the
6.2 Acquisition
requirements.
following:
a.
Title,
number, and date of this specification.
b.
Type, class, and size required (see 1.2).
c.
Issue of DODISS to be cited in the solicitation, and if
required, the specific issue of individual documents
referenced (see 2.1.1 and 2.2).
First
article,
if
required
(see
3.1).
d.
e.
Specify system of units for measuring and indicating devices
(see 3.2.1).
f.
Additional safety and health requirements, if required
(see 3.2.5).
15
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business