MIL-P-80041D
When specified (see 6.2), t i e r o d s s h a l l b e f u r n i s h e d .
3.4.8 Tie rods.
Tie rods shall be of the size and strength to minimize deflection of the press
frame.
ne shall be wired to conform to
3.4.9 Electrical requirements. The mach
2 ) , each machine shall be designed
NFPA 79.
Unless otherwise specified (see 6
otherwise
230/460-volts. Unless
to operate on 3-phase, 60-Hertz (Hz),
tially wired for operation on 460
specified (see 6.2), the press shall be in
volts.
Motors shall be rated for continuous duty and shall have
3.4.9.1 Motors.
ball or roller bearings of the sealed and permanently lubricated type. Unless
otherwise specified (see 6.2), each motor shall have a dripproof enclosure.
A l l motors shall meet the requirements of NEMA MG1.
3.4.10 W o r k l i g h t .
The light shall have a protective shield, and on-off
seitch,
and
shall
be
adjustable to reflect maximum light on the work area.
3.4.11 Hour meter.
When specified (see 6.2), the press shall be equipped
with an hour meter.
The hour meter shall be installed to display accumulated
operating
the
time
of
the
main
drive
motor.
The
meter
shall
be
of
nonresetting type and shall have a range of O to 9,999 hours in increments of
not. greater than 1 hour.
The meter shall be sealed to prevent the entrance of
and vibration
dust and moisture and shall be mounted to withstand shock
generated by the press.
3.5 Size and capacity.
Unless otherwise specified (see 6.2), the size and
II,
or
111
c a p a c i t y o f t h e p r e s s s h a l l m e e t the requirements
of tables I,
for the type, class, and size press specified.
(see 6.2), the physical
W h e n specified
3.5.1 Physical size limitations.
length
size of the machine shall
not e x c e e d t h e h e i g h t , w i d t h ,
and
r e s t r i c t i o n s s p e c i f i e d b y t h e p r o c u r i n g a c t i v i t y t o e n s u r e the machine w i l l
fit in its future operating location.
3.6 Alignment accuracy.
The bottom surface of the slide shall be parallel
to the top surface of the bed or bolster within the following accuracies:
a. 0.002 inch per foot at top of stroke.
b. 0.003 inch per foot at midstroke.
the
All standard equipment normally provided with
3.7 Standard equipment.
manufacturer's commercial press shall be furnished.
3.8 Optional equipment.
Optional equipment shall be furnished as specified
and fully described (see 6.2). The optional equipment provided shall be
functional without requiring modification of the equipment or machine.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business